To get the upper ignition cables through to the plugs, they need to pass through the baffles. Section 47 shows these are "supplied with engine" - well, not in my case unfortunately.
.png)
Spruce sells some designed for slick magneto leads, but since i am using 8.5mm MSD leads, these woudld need to be modified. The other issue, or the eye-watering cost!
.png)
So the solution - over to OnShape!
.png)
The part consists of 2 sections which overlap - and are held in with AN3 bolts.
.png) |
| Bottom |
.png) |
| Top |
The OnShape file can be accessed here.
My Dad 3d printed these on his resin printer, using 100c high-temp resin.
No comments:
Post a Comment